Krois-Modell Car-System 7027, Hall sensor for installation in the roadway

Hall sensor for the position signal of the vehicles of Krois model Car-System, for a 16-fold feedback module with galvanically isolated optocoupler inputs.

The sensor is installed before turns, stops, driveways, exits, intersections, etc.

The power supply is 12-24Volt

Installing the sensor is very simple, drill an 8mm diameter hole in the road and then push the sensor into the hole. The opening can be drilled in the middle of the road or at the edge of the road, so that the vehicle still reaches over the sensor.

If the sensor is mounted in the center, the magnet is sufficient from the grinder, but be careful, the magnetic tape should be disconnected before and after the sensor.

If it is mounted on the edge, the supplied magnet must be glued to the underside of the vehicle.The sensor is camouflaged at the top by a manhole cover.

The cables on the sesor are 150mm long, the blue cable is 12-24 volts plus, the black minus, the yellow cable is connected to the Littfinski module. (310101, 310102, 310103)

Technical specifications:

Size 8mm diameter x 8mm installation depth

Cable 150mm length

Connection 12-24 volts stabilized DC voltage

Blue = Plus

Black = minus

Yellow = to the detector

If the sensor does not report anything, exchange the polarity plus and minus

Detection range 13.5mT release, 5mT release

Test condition 25 ° C

Voltage - supply 2.7V to 18V

Power supply (max.) 6mA

Current output (max.) 20mA

Output type open collector

Features temperature compensated

Operating temperature -40 ° C to 150 ° C (TJ)