Krois-Modell Car-System 9051, Servo for the middle of the intersection, assembled

This servo switch is used when 2 magnetic strips cross at the intersection to ensure safe driving of the vehicles.

Content:

1x assembled servo, 1x rudder horn with magnetic strips 3x1mm,Servo 180°

Before gluing, try to make sure everything works. The servo mount can be dotted with hot glue to release it if it's too low or too high. The servo should be approx. 1mm lower than the road, then fix it with hot glue or white glue. Cut a foil or thick sheet of paper into a rectangle and stick it over the hole in the servo mount when the road surface is filled. The servo rudder horn should move slightly under the foil and not stick.

We recommend the servo decoder from ESU 51832 or Decoderwerk DW90101