Krois-Modell KKstB_1, Main signal 2 conceptual, red/green

KKstB signals from 1934

The signal is on a scale of 1:87.

The signal mast and base are made of plastic, the mast is reinforced on the inside with a brass tube.

The signal wing is made of reinforced special paper.

A Sunny White LED is installed for lighting during night operation and can be powered by the decoder or with a direct current source of 12-20V.

The signal is supplied without a drive and without a decoder.

If a drive or a decoder is included, we will install and set it up, the address of the decoder for servo and light is 1 and 2 in switch mode.

You can configure the drive and decoder above.

Signal base size; LXB 27mmx22mm

Total signal height: 130mm

Installation opening: D 18mm

CV settings for the wing signal

CV 49 is the value 16: Output 1 is controlled normally

CV113 is the value 1: speed for rocking

CV114 is the value 8: swing position in degrees

CV115 is the value 2: rocking at the ends

CV116 is the value 20: smooth running

CV117 is the value 175: setting position right

CV118 is the value 130: setting position left

CV121 is the value 1: servo address

CV122 is the value 20: servo speed

CV126 is the value 50: dimming value for output 1 Lamp

CV128 is value 2: Lamp address