Krois-Modell KKstB_2, Semaphore signal 2, Hp0/Hp1

KKstB signals from 1934

The signal is in 1:87 scale.

The signal mast and base are made of plastic, the mast is reinforced internally with a brass tube.

The signal vane is made of reinforced special paper.

The signal is delivered without a motor and without a decoder.

If a motor or decoder is included, we will install and configure it. The decoder address for servo and light is 1 and 2 in turnout mode.

Dimensions

Signal base size; LxW 27mmx22mm

Total signal height: 130mm

Installation opening: D 18mm

Settings for the built-in servo. These values ​​are only valid in conjunction with our decoder and servo.

CV settings for the wing signal

CV 49 is value 16: Output 1 is controlled normally

CV 113 is value 1: Speed ​​for rocking

CV 114 is value 8: Swing position in degrees

CV 115 is value 2: Rocking at the ends

CV 116 is value 20: Smooth running

CV 117 is value 175: Setting position right

CV 118 is value 130: Setting position left

CV121 is value 1: Servo address

CV122 is value 20: Servo speed

CV126 is value 50: Dimming value for output 1 lamp

CV128 is value 2: Lamp address