LaserCraft 93-315, platform steps, without roof and platform

The platform stairs are standard without a platform roof and without a platform platform.

The platform stairs are assembled and installed in the platform from bottom to top.

The opening of the cutout should be LxW 121mm x 28mm, the installation depth is 31mm from the top edge of the platform.

The stairs can be installed on platforms with a width of 40-90mm.

If a platform is to be added to the stairs, this would be article LC93-316, width from 40-90mm, always in 5mm increments.

If a roof is also to be added, this would be article LC93-317, width from 40-90mm, always in 5mm increments.

The same applies to the lighting, the lighting set is designed for 12-24V DC/AC voltage.

The LEDs are pure white.

When assembling, the platform stairs are glued into the platform from below.

The assembly is the same as in H0, only the stair walls should be flush with the top edge of the platform. Product photos 3 and 4.

The instructions for the platform roof and the stairs can be found under Downloads on the krois-modell.at homepage.